Archives

DIY Retro Oven Mitt and Hot Pad

If you have been wanting to replace your old oven mitt and hot pad then why not make your own! I am going to help you through an easy step by step guide to making an oven mitt and hot pad in your favourite retro fabric to suit your retro kitchen. It is an easy project and takes very little time to make. You can use left over fabric and the only cost may be the heat proof insulated wadding, which you will need 1/2 a metre of, depending on its width.

What You Will Need:

  1. Insulated wadding
  2. Retro fabric
  3. Matching Ribbon
  4. Matching cotton
  5. Sewing machine
  6. Paper & pen
  7. Scissors

Mitt

1. To begin with, trace around your hand on a piece of paper. Do an over exaggerated trace as I have done in the picture below. This allows for any size hand to use the glove and also ease to pull on and off.

Cut around the trace.

2. Use this as your pattern for cutting out your fabric piece. You will need 4 pieces of your retro fabric for the glove, cutting it to the pattern shape. I used 4 pieces of fabric as I prefer the inside of the glove to be fabric rather than wadding as I do not like the feel of wadding on my hand.

3. Next, cut out all your wadding. You will need 4 pieces of your wadding for the glove, cutting it to the pattern shape. This will give you extra padding from the heat.

4. Now grab two pieces of fabric and 2 pieces of your wadding and pin together matching up all sides evenly and having the correct side of fabric on the outside and wadding on the inside. Sew close to the edges on all sides leaving no openings.

5. Do the same with the remaining two pieces of fabric and two pieces of wadding. Once again, pinning together, matching up all sides evenly and sewing close to the edges.

6. Now you can pin the two sewn pieces together leaving the bottom piece open, as this allows your hand to enter. On one side before you get to the end of the seam add a ribbon loop along the seam (do the loop on the inside as we will be turning the glove through so the seams are on the inside & the hoop will then be on the outside ) This loop will allow you to hang your mitt, see picture below.

Once sewn turn the glove inside out so the seams are on the inside (not showing)

7. Now you can hem the bottom or use the remaining ribbon to hem, like I have done below.

Hot Pad

This is a really easy process:

1. Cut out fabric 2 squares & 2 wadding squares. It is usually recommended that you do a square 17.5cm x 17.5cm, but it is really up to you.

2. Place fabric pieces right sides together and wadding on the outside, then sew all sides together leaving a 5cm gap to pull it through to the right side

3. When you have pulled it completely through to the right side. Use a knitting needle or something similar to push the corners to check they are through completely. Then you can finish sewing the seam closed. As you sew the seam closed you can use ribbon to make a loop for easy hanging.

4. To tidy it up, I like to stitch around the edges.

Your kitchen mitt and hot pad is now complete

Let me know how you go, I would love to see your finished product!

Back soon….

Ridiculously Retro Xx

DIY Denim

Do you have pairs of jeans or denim jackets, and find that you aren’t wearing them as often anymore? I decided to make some changes and up-cycle my denim to portray more personality. Here are some different ideas to make your denim extra fancy and express yourself!

1.Denim Jacket with Tulle Hemline

I purchased this jacket already like this, but this an easy DIY project. This denim jacket has tulle added to the bottom and bling badges pinned. All you need to do is purchase tulle and sew it to the inside of the hem of the denim jacket. You can sew on as many layers of the tulle depending on the look you desire or you can gather the tulle and sew along the hemline.

2. Painted Denim

If you are a talented artist, or know someone who is, then you can paint on your denim! Make sure you draw your image first, using fabric pencils. Then with fabric paint you can go ahead and paint your desired image. You can do basic images or fancy depending on your preference. Be careful to never iron straight on the paint.

3. Iron on Transfers on Denim

Image

If you’re not too artistically skilled, another option is to purchase an iron-on transfer. You can find many excellent retro inspired designs online. Follow the instructions, but most just require ironing upside down onto the fabric. Be careful to never to iron straight on the transfer, when ironing your denim, as it may melt!

4. Patches on Denim

Image

You can purchase retro patches and sew or iron them onto your denim. Patches are an easy and affordable option to decorate your denim, and there are so many designs to choose from online, at markets or sewing shops.

5. Embroidered Denim

Embroidery is a super fun DIY if you already have the skills, or are willing to learn! There are plenty of online videos and tutorials making it easy to learn. I am planning on embroidering cherries on a pair of denim capris, so check out my blog in the next few weeks! Some sewing machines also have embroidery functions.

6. Fabric on Denim

Retro fabric can be sewn onto your denim, for a fresh look! To make it look professional I like to sew the fabric along the sewn sections of the denim, such as collars, pockets or the back seam of the jacket, like above.  Place the fabric over the area you want to sew it on, and cut it about 2.5cm bigger. Pin it to the area while tucking the edges under, for a tidy edge. Now you’re ready to sew! Try sewing as close as possible to the fabric edge. With excess fabric you can also make matching headbands, scarves or bags.

Double denim was big in the 1950’s, and I have achieved this look by sewing the same fabric on denim pants and jacket!

I hope this inspires you try up-cycling your old denim items. You can even purchase second hand denim from op shops, markets or vintage clothes shops to try out your DIY ideas. Send me photos of your finished products, I would love to see them.

Back soon….

Ridiculously Retro Xx

How to Create a Retro Bedroom

Bedroom decor has changed over the decades. I love the look of mixing retro items with some modern day necessities, while keeping the retro feel to my decor.

Below are some examples of bedrooms through the decades to use as an influence.

1950s style bedroom

1960s style bedroom

1970s Style lBedroom

🌷🌷🌷🌷🌷🌷🌷🌷🌷🌷🌷🌷🌷

For my room I have decorated it in a vintage inspired retro style.

JH Lynch & Johnny Cash artwork & 50s wall vases & retro ornaments

50s bedroom chair that I covered in retro fabric and left the grey fabric on the skirts, flamingo light & retro style mirror

Some retro ornaments on shelves that we made by cutting into the wall

My moulin rouge style bedroom light on a hat box that I made into a bed side table by adding retro furniture legs, sourpuss tattoo print umbrella, sourpuss pillows & Sailor Jerry tattoo print quilt that I made by sewing the fabric to the centre of a black quilt (and my cat 🐱)

Vintage suitcase set stacked up which is useful for extra storage, vintage hairdryer, vintage sewing mannequin, Jolley Big eye prints, and reproduction circle shelves, retro style matching frames that I placed Marilyn Monroe movie posters in, which I purchased as an old movie poster book from a Salvos store.

🌴🌴🌴🌴🌴🌴🌴🌴🌴🌴🌴🌴🌴

For my daughters room, she wanted it decorated in a retro tiki vibe.

The quilt is a modern tropical theme with flamingos, palm trees and pineapples

I accentuated this peacock chair by painting it white then added flowers to go with the bedroom theme

Pops of colour through the room add the the look. I made an old suitcase into a bedside table by painting it and adding retro wooden table legs

More pops of colour

A round beveled edge vintage mirror, flamingo, tropical print & surfboard, bamboo tree and more colour add to the theme

A Cuban print and Barsony lampshade and to the accessories of the room

And a retro tiki room would not be complete without a kitch hula doll

Coconut containers with flowers attached, that I found in a St Vinnies store are handy containers for hair ties and clips

🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺🌺

There are many options for creating a vintage bedroom. Here are some ideas for that retro feel:

  1. Use vintage lighting
  2. Use vintage textures and patterns
  3. Do a feature wall in retro wallpaper
  4. Get your hands on vintage artwork or prints and place in vintage frames
  5. If you don’t have a vintage style bed then make a statement bed head
  6. Add an ornate vintage mirror
  7. Buy some vintage furniture
  8. Get some vintage ornaments
  9. Get some vintage Manchester or create your own in a vintage style using florals, gingham or retro fabrics

Whatever retro style that you go for in your bedroom, you have endless options in creating it. I hope I have inspired you! Have fun creating!!

Back soon…..

Ridiculously Retro Xx

How To Revamp a Cork Memo Board

I mentioned before that I would show you how to revamp a memo board…. This is a quick and easy project and can be useful artwork in your room!

Here are two that I created. For both,Β  just purchase a cheap cork memo board in whatever size you require.

1. Cork memo board in a frame

I made this cork board to match all the other frames in my bedroom.

The two frames in my room that I put Marilyn Monroe movie posters in, and my mirror

Here are the steps:

  1. Take the mirror or picture out of the frame. Take the cork board out of its frame and trace the mirror/picture shape onto your memo cork board.

2. Next get a jigsaw or knife and cut out the shape.

3. Place the memo cork board into the frame. It is best if your frame has the metal clips to bend back into place. If not, you could hot glue it into the frame. If it is a wooden frame you could use small nails to keep it into place.

4. Voila! You can put your new memo board up and start using it.

2. Cork memo board covered in fabric

I made this cork memo board for my daughter as her room is retro tiki inspired. Here are the steps:

  1. Pick a fabric and iron the piece, as it works best with no creases.
  2. Take the frame off the memo board, carefully, as you will still need to use the frame. You should be able to take it off by opening only one corner.

3. Next carefully staple the fabric onto the cork board at the back. Carefully pulling the fabric tight at all times, prior to each staple, and fold over corners tidily.

4. Place the frame back onto the cork board. Use a staple gun to close the one corner that you opened.

5. Your frame is now ready to use!

3. Some other ideas are:

Example 1

This example is just a cork board divided into 9 sections with each section decorated individually. You can paint them with normal paint or blackboard paint, or cover it in fabric, or leave it plain. Decorate in any style you prefer!

Example 2

The above example is a piece of wood covered in fabric and stapled on the back, then ribbon crossed over and again stapled to the back. In each X section add a pin for decoration & for sturdiness.

Example 3

This example is a vintage frame with chicken wire stapled to the frame back. You could use fabric or an artwork on the back for a different look. Memos are held on with small pegs, that you can pick up in a craft store.

I have given you some ideas…. but the possibilities are endless! Let your creativity go wild. Show me your creations, I would love to see them!!

Back soon….

Ridiculously Retro Xx

Get Crafty on a Vintage Suitcase

My daughter wanted to store her craft and sewing in a box, so I suggested we decoupage a large vintage suitcase with pictures that are inspirational to her.

Here are the steps to decoupaging a vintage suitcase.

What you will need:

  • Magazines
  • Scissors
  • Craft glue
  • Vintage suitcase
  • Small paint brush
  • Clear paint spray or decoupage clear gloss

1. Pick your item

First you need to pick which vintage suitcase you want to use. Pick one that closes up securely and is big enough for all your items.

Above: The vintage suitcase we chose to use

2. Cut out your pictures

Get some of your favourite magazines and cut out some inspirational pictures. You can also download images, use newspaper, music sheets, concert tickets, photos, children’s drawings, or any paper items. The possibilities are endless!!

Trim each picture to not overlap. Then set them out on your suitcase as to what looks the most aesthetically pleasing for you!

Above: magazines to use to cut out pictures

Above: cut out inspirational pictures

3. Glue your pictures

Use a strong craft glue and stick your pictures on. With a small paint brush, spread the glue out evenly on the back of the picture. Glue the images where you prefer, as you can see I preferred to cover all sides of my suitcase!

Above: one side of suitcase

Above: Other side of vintage suitcase

4. Drying Time

I prefer to leave it a few days to dry completely. Each day check that there are no pictures lifting off or peeling at the edges.Ensure to glue any flapping edges back on.

Above

5. Finishes

The suitcase is completely dry and you are happy with the look… NOW you can finish the project! Give the suitcase either a clear coat of spray paint or enamel. You will need to do a few coats to protect your images and leave the relevant amount of drying time between each coat. The more layers that you spray on your suitcase, the better the suitcase finish will be. Another option is to cover it with decoupage clear gloss if you prefer a thick glass coating. Then you will need to leave it a few days again.

Image above: finished product

The above process can be followed to decoupage any item.

Featured Image

Have you ever decoupage a product? Send me photos, I would love to see them!

Back soon….

Ridiculously Retro xx